Quick
Disconnect Plug
The 7013 Quick Disconnect
Plug is a two-wire connector designed to mate
with all MS 3509 style (Rebling's 7002 series)
receptacles.
This compact connector features self-aligning, compliant sockets that compensate for part to part dimensional tolerances and relative motion of the mating receptacle’s contact pins. This feature results in a low insertion force and minimal wear on the 7013 shaft and sockets. The 7013’s silver-plated copper alloy sockets also feature a large contact area resulting in very low electrical losses across the socket – receptacle pin interface.
The 7013 body is molded from a chemically-resistant and heat resistant plastic. Embossed polarity markings and a molded keyway on the body ensure that correct polarity is achieved with the mating receptacle. Engagement with the receptacle is accomplished by rotating a “T” shaped handle to a locked detent position. This handle is over-molded onto a hardened stainless steel shaft. The maximum torque that can be applied to fasten the cable lugs is also embossed on the molded body. Protective coverings over the socket area are molded from the same type plastic as the body and are permanently attached using an ultrasonic welding process.
The 7013 is designed to meet all the mechanical, electrical, and environmental requirements of MS 3349-2. It is the same design as the 7017, which is on the QPL for MS3349-2, except there is no cover (click here to watch a video demonstration of the difference). It can accommodate up to 000 wire on both the positive and negative terminals.
The 7013 is also available without the molded handle for applications with space constraints. Instead of the handle, there is a slotted shaft for screwdriver installation (7013-SS)
|
